Edition: BP 2025 (Ph. Eur. 11.6 update)
Action and use
Analgesic; antipyretic; central nervous system stimulant.
DEFINITION
Paracetamol and Caffeine Tablets contain Paracetamol and Caffeine.
The tablets comply with the requirements stated under Tablets and with the following requirements.
Content of paracetamol, C8H9NO2
95.0 to 105.0% of the stated amount.
Content of caffeine, C8H10N4O2
95.0 to 105.0% of the stated amount.
IDENTIFICATION
A. Shake a quantity of the powdered tablets containing 0.5 g of Paracetamol with 20 mL of acetone, filter and evaporate the filtrate to dryness. The infrared absorption spectrum of the residue, Appendix II A, is concordant with the reference spectrum of paracetamol (RS 258).
B. Carry out the method for thin-layer chromatography, Appendix III A, using the following solutions.
(1) Mix with the aid of ultrasound a quantity of powdered tablets containing 65 mg of Caffeine in 10 mL of methanol, and filter (a 0.2-µm nylon filter is suitable).
(2) 0.65% w/v of caffeine BPCRS in methanol.
(3) 0.65% w/v of caffeine BPCRS and 5% w/v of paracetamol BPCRS in methanol.
CHROMATOGRAPHIC CONDITIONS
(a) Use as the coating silica gel F254 (Merck silica gel 60 F254 plates are suitable).
(b) Use the mobile phase as described below.
(c) Apply 1 µL of each solution.
(d) Develop the plate to 15 cm.
(e) After removal of the plate, allow it to dry in air and examine under ultraviolet light (254 nm).
MOBILE PHASE
5 volumes of acetic acid, 5 volumes of ethanol, 5 volumes of water and 50 volumes of ethyl acetate.
SYSTEM SUITABILITY
The test is not valid unless the chromatogram obtained with solution (3) shows two clearly separated spots.
CONFIRMATION
The spot corresponding to caffeine in the chromatogram obtained with solution (1) corresponds in position to the principal spot in the chromatogram obtained with solution (2).
C. In the Assay for caffeine, the chromatogram obtained with solution (1) shows a peak with the same retention time as the principal peak in the chromatogram obtained with solution (2).
TESTS
Dissolution
Comply with the dissolution test for tablets and capsules, Appendix XII B1, using the following conditions.
TEST CONDITIONS
(a) Use Apparatus 2 and rotate the paddle at 50 revolutions per minute.
(b) Use as the medium 900 mL of a phosphate buffer (pH 5.8), at a temperature of 37°, prepared in the following manner. Mix 250 mL of 0.2M potassium dihydrogen phosphate and 18 mL of 0.2M sodium hydroxide, and dilute to 1000 mL with water.
PROCEDURE
Carry out the method for liquid chromatography, Appendix III D, using the following solutions.
(1) After 45 minutes, withdraw a sample of the medium and filter. Use the filtered medium, diluted with dissolution medium, if necessary, to produce a solution expected to contain 0.0056% w/v of Paracetamol.
(2) 0.0056% w/v of paracetamol BPCRS in the dissolution medium.
CHROMATOGRAPHIC CONDITIONS
(a) Use a stainless steel column (10 cm × 4.6 mm) packed with octadecylsilyl silica gel for chromatography (5 µm) (Nucleosil C18 is suitable).
(b) Use isocratic elution and the mobile phase described below.
(c) Use a flow rate of 1.5 mL per minute.
(d) Use an ambient column temperature.
(e) Use a detection wavelength of 243 nm.
(f) Inject 20 µL of each solution.
MOBILE PHASE
0.01M sodium pentanesulfonate in a mixture of 22 volumes of methanol and 78 volumes of water, adjusted to pH 2.8 using 2M hydrochloric acid.
When the chromatograms are recorded under the prescribed conditions the retention time of paracetamol is about 3 minutes.
DETERMINATION OF CONTENT
Calculate the total content of paracetamol, C8H9NO2, in the medium using the declared content of C8H9NO2 in paracetamol BPCRS.
LIMITS
The amount of paracetamol released is not less than 75% (Q) of the stated amount.
Related substances
Carry out the method for liquid chromatography, Appendix III D using the following solutions prepared in solution A.
Solution A: 0.23% w/v of sodium chloride in a mixture of 30 volumes of mobile phase B and 70 volumes of mobile phase A.
(1) Mix with the aid of ultrasound a quantity of the powdered tablets containing 0.5 g of Paracetamol with 50 mL and filter (Chromafil RC 45/25 is suitable).
(2) Dilute 1 volume of solution (1) to 100 volumes.
(3) 0.0001% w/v of 4-aminophenol (paracetamol impurity K).
(4) 0.00001% w/v of 4′-chloroacetanilide (paracetamol impurity J).
(5) Dilute 1 volume of solution (2) to 10 volumes.
CHROMATOGRAPHIC CONDITIONS
(a) Use a stainless steel column (15 cm × 4.6 mm) packed with end-capped octadecylsilyl silica gel for chromatography (2.6 µm) (Kinetex C18 100A is suitable).
(b) Use gradient elution and the mobile phase as described below.
(c) Use a flow rate of 0.8 mL per minute.
(d) Use a column temperature of 35°.
(e) Use detection wavelengths of 212 nm and 246 nm.
(f) Inject 20 µL of each solution.
MOBILE PHASE
Mobile phase A 5 mM sodium octanesulfonate, adjusted to pH 2.2 with orthophosphoric acid.
Mobile phase B methanol R1.
| Time (Minutes) | Mobile phase A (% v/v) | Mobile phase B (% v/v) | Comment |
| 0-2.5 | 80→70 | 20→30 | linear gradient |
| 2.5-20 | 70 | 30 | isocratic |
| 20-30 | 70→20 | 30→80 | linear gradient |
| 30-32 | 20→80 | 80→20 | linear gradient |
| 32-37 | 80 | 20 | re-equilibration |
When the chromatograms are recorded under the prescribed conditions, the relative retentions with reference to paracetamol (retention time about 3 minutes) are: caffeine impurity B, about 0.6; caffeine impurity F, about 1.2; caffeine impurity A, about 1.3; caffeine, about 1.6; paracetamol impurity K, about 2.3; caffeine impurity E, about 2.5; paracetamol impurity J, about 6.1.
SYSTEM SUITABILITY
The test is not valid unless:
in the chromatogram obtained with solution (3) at 212 nm, the signal-to-noise ratio of the peak due to paracetamol impurity K is at least 10.
in the chromatogram obtained with solution (4) at 246 nm, the signal-to-noise ratio of the peak due to paracetamol impurity J is at least 10.
LIMITS
For paracetamol impurity J at 246 nm
In the chromatogram obtained with solution (1):
the area of any peak corresponding to paracetamol impurity J is not greater than the area of the principal peak in the chromatogram obtained with solution (4) (10 ppm).
For all other impurities at 212 nm
Identify any peaks due to caffeine impurity B and E, and multiply the peak areas by a correction factor of 2.9 and 3.3, respectively.
In the chromatogram obtained with solution (1):
the area of any peak corresponding to paracetamol impurity K is not greater than the area of the corresponding peak in the chromatogram obtained with solution (3) (100 ppm);
the area of any other secondary peak is not greater than the area of the peak due to paracetamol in the chromatogram obtained with solution (5) (0.1%);
The total impurity content is not greater than 0.5%.
Disregard any peak, excluding paracetamol impurities J and K, with an area less than half the area of the peak due to paracetamol in the chromatogram obtained with solution (5) (0.05%).
ASSAY
For paracetamol
Weigh and powder 20 tablets. Carry out the method for liquid chromatography, Appendix III D, using the following solutions protected from light.
(1) Shake a quantity of the powdered tablets containing 0.5 g of Paracetamol with 100 mL of the mobile phase, dilute to 200 mL with the same solvent, filter through a glass-fibre filter (Whatman GF/C is suitable) and dilute 5 mL of the filtrate to 250 mL with the mobile phase.
(2) 0.005% w/v of paracetamol BPCRS in the mobile phase.
CHROMATOGRAPHIC CONDITIONS
The chromatographic conditions described under Dissolution may be used.
DETERMINATION OF CONTENT
Calculate the content of C8H9NO2 in the tablets using the declared content of C8H9NO2 in paracetamol BPCRS.
For caffeine
Weigh and powder 20 tablets. Carry out the method for liquid chromatography, Appendix III D, using the following solutions protected from light.
(1) Shake a quantity of the powdered tablets containing 30 mg of Caffeine with 100 mL of the mobile phase, filter through a glass-fibre filter (Whatman GF/C is suitable) and dilute 5 mL of the filtrate to 50 mL with the mobile phase.
(2) 0.003% w/v of caffeine BPCRS in the mobile phase.
CHROMATOGRAPHIC CONDITIONS
The chromatographic conditions described under Dissolution may be used with a wavelength of 220 nm.
DETERMINATION OF CONTENT
Calculate the content of C8H10N4O2 in the tablets using the declared content of C8H10N4O2 in caffeine BPCRS.
LABELLING
The label states the quantities of Paracetamol and Caffeine.
IMPURITIES
The impurities limited by the requirements of this monograph include impurities J and K listed under Paracetamol, and impurities A, B, E and F listed under Caffeine.
